aka » Пн апр 07, 2014 3:07 pm
Вижу кнопочку возле "Enable Network booting". Может, на неё надо нажать, чтобы разрешить загрузку по сети?
Гугл такую методичку показал:
===
pfSense v1.23
If your pfSense device is acting as the DHCP server, you will need to perform the following steps:
Login to your pfSense web admin interface
Go to Services > DHCP Server
Scroll Down to "Enable Network booting" Click the button labeled Advanced to "Show Network booting" options
Check the box to "Enables network booting"
Enter the IP address from the network boot server: X.X.X.X where X.X.X.X is the IP of your FOG server
Enter the filename used for network booting: pxelinux.0
Click the Save button
Note: You need both a filename and a boot server configured for this to work!
===
Вместо "IP of your FOG" пиши IP TFTP сервера.
Вместо "pxelinux.0" пиши 5.1.28\wtware.pxe (последняя версия втвари называется 5.1.62!)
И убери 066 и 067.
Вижу кнопочку возле "Enable Network booting". Может, на неё надо нажать, чтобы разрешить загрузку по сети?
Гугл такую методичку показал:
===
pfSense v1.23
If your pfSense device is acting as the DHCP server, you will need to perform the following steps:
Login to your pfSense web admin interface
Go to Services > DHCP Server
Scroll Down to "Enable Network booting" Click the button labeled Advanced to "Show Network booting" options
Check the box to "Enables network booting"
Enter the IP address from the network boot server: X.X.X.X where X.X.X.X is the IP of your FOG server
Enter the filename used for network booting: pxelinux.0
Click the Save button
Note: You need both a filename and a boot server configured for this to work!
===
Вместо "IP of your FOG" пиши IP TFTP сервера.
Вместо "pxelinux.0" пиши 5.1.28\wtware.pxe (последняя версия втвари называется 5.1.62!)
И убери 066 и 067.