Config file on disk: server = 10.102.24.13 vnc=on vnc_password=12345 usb=1-1.4, 1-1.5 sound=on microphone=on configs.txt # For more options and information see # http://www.raspberrypi.org/documentation/configuration/config-txt.md # Some settings may impact device functionality. See link above for details # Uncomment if you get no picture on HDMI for a default "safe" mode. #hdmi_safe=1 # Uncomment this if your display has a black border of unused pixels visible # and your display can output without overscan. disable_overscan=1 # Uncomment if hdmi display is not detected and composite is being output. #hdmi_force_hotplug=1 # Uncomment to force a specific HDMI mode (this will force VGA). #hdmi_group=1 #hdmi_mode=1 # Force the monitor to HDMI mode so that sound will be sent over HDMI cable. #hdmi_drive=2 # Uncomment to increase signal to HDMI, if you have interference, blanking, or # no display. #config_hdmi_boost=4 # Uncomment to overclock the arm. 700 MHz is the default. #arm_freq=800 disable_splash=1 #hdmi_group=2 # 800x600: hdmi_mode=9 # 1024x768: hdmi_mode=16 # 1280x1024: hdmi_mode=35 # 1360x768: hdmi_mode=39 # 1400x1050: hdmi_mode=42 # 1440x900: hdmi_mode=47 # 1600x1200: hdmi_mode=51 # 1680x1050: hdmi_mode=58 # 1366x768: hdmi_mode=81 # 1920x1080: hdmi_mode=82 # 1920x1200: hdmi_mode=69 framebuffer_depth=32 # Uncomment for 16-bit color. It is up to two # times faster than default 32-bit. #framebuffer_depth=16 # Enable onboard audio (HDMI or jack). # dtparam=audio=on # Removes the warning overlay. #avoid_warnings=1 # Additionally allows turbo when low-voltage is present. #avoid_warnings=2